Hello Guest it is April 18, 2024, 12:43:13 PM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: Powermill to Mach3 post  (Read 17496 times)

0 Members and 1 Guest are viewing this topic.

Offline Garyh

*
  • 19 19
    • View Profile
Powermill to Mach3 post
« on: April 22, 2007, 08:13:36 AM »
Can any one help ?
Logged

Offline Graham Waterworth

*
  • *
  • 2,672 2,672
  • Yorkshire Dales, England
    • View Profile
Re: Powermill to Mach3 post
« Reply #1 on: April 22, 2007, 08:17:20 AM »
In what way?
Logged
Without engineers the world stops

Offline Garyh

*
  • 19 19
    • View Profile
Re: Powermill to Mach3 post
« Reply #2 on: April 22, 2007, 08:20:39 AM »
Post processor for powermill
Logged

Offline Graham Waterworth

*
  • *
  • 2,672 2,672
  • Yorkshire Dales, England
    • View Profile
Re: Powermill to Mach3 post
« Reply #3 on: April 22, 2007, 08:22:16 AM »
The fanuc 6 one will be very very close. Try it.
Logged
Without engineers the world stops

Offline Garyh

*
  • 19 19
    • View Profile
Re: Powermill to Mach3 post
« Reply #4 on: April 22, 2007, 08:25:23 AM »
Many thanks, will give it a go cheers.
Logged

Offline lukecnc

*
  • 1 1
    • View Profile
Re: Powermill to Mach3 post
« Reply #5 on: May 10, 2012, 04:17:04 AM »
There is some one that have fanuc6 post processor for powermill, I have already worked with fanuc6m but there is some problem using it. Can any one help me? thanks
Logged

Offline Graham Waterworth

*
  • *
  • 2,672 2,672
  • Yorkshire Dales, England
    • View Profile
Re: Powermill to Mach3 post
« Reply #6 on: May 10, 2012, 04:20:54 AM »
The DelCAM forum is your best bet.

http://forum.delcam.com/

Graham
Logged
Without engineers the world stops
Pages: 1   Go Up
« previous next »