Im having an issue with copycat and probing a circle.
I have Mach3 .3.043.066 and when doing 3d PROBE from the menu of Mach3 it works at the speed that i set probing in CopyCat(this is good, so i can alter it for large circle and small circle probing)
This works fine.
However, if i go to probe in Copycat (circle centre probe) it moves exactly 4mm then stops and reverses etc etc. On looking at the code in the Copycat screen it says
Code "G91 G31Y 4 F" &ProbeFeed
which should move in the y + direction for 4 seconds or until it hits the wall of the circle.
Thats bad
Any one have ideas, is it a bug?, have I missed a setup config. setting? Am i just missing something entirely? Or does the G91(set Distance mode) turn the G31Y4 into a pure distance operation?
I will investigate G31 as soon as I find some info on it. First time I've used/seen it