Hello Guest it is August 22, 2019, 12:29:03 PM

Author Topic: RADIUS TO END OF ARC DIFFERS FROM RADIUS TO START  (Read 5787 times)

0 Members and 1 Guest are viewing this topic.

Offline Hood

*
  •  25,849 25,849
  • Carnoustie, Scotland
    • View Profile
Re: RADIUS TO END OF ARC DIFFERS FROM RADIUS TO START
« Reply #20 on: February 03, 2015, 06:04:26 AM »
Either attach or email both the bbcd and the xml and I will take a look.
Hood

Offline Hood

*
  •  25,849 25,849
  • Carnoustie, Scotland
    • View Profile
Re: RADIUS TO END OF ARC DIFFERS FROM RADIUS TO START
« Reply #21 on: February 03, 2015, 04:49:41 PM »
Mick,
 loaded your bbcd and dont see a problem with it however the code is not good. I tried changing to dia mode but still it was not good.
 If I use my PP and use Dia mode (what I always use) then it is fine, well as long as Mach is in Dia mode as well.
So something wrong in the PP I think when it comes to rad mode. See what BobCAD say when you get them to do a PP for you.

Hood
Re: RADIUS TO END OF ARC DIFFERS FROM RADIUS TO START
« Reply #22 on: February 03, 2015, 05:26:19 PM »
Cheers Hood for taking a look.

Mick