Hello Guest it is May 09, 2021, 09:43:49 AM

Author Topic: Mach3 help please / Steps jerking  (Read 1924 times)

0 Members and 1 Guest are viewing this topic.

Mach3 help please / Steps jerking
« on: January 27, 2015, 03:05:11 AM »

 My 3 axis CNC works fine with Mach3. I had a 3 axis USB movement card and I have changed it to a standard 5 axis BOB as I thought there was a problem with the first board. But It still exists.
 If I load a large Gcode into Mach3, when I try to toggle the axis or zoom in on Mach3's graphic table display, the stepper motors slow down steps to almost individual steps. I ran a latency test on my PC, which the results were good. ( servo / max int 1011675, max jitter 15071  // Base max int 42076 // max jitter 19317 )

Any Ideas Please ?



Re: Mach3 help please / Steps jerking
« Reply #1 on: January 27, 2015, 03:41:21 PM »
Note .
 
 This only happens with large Gcodes loaded into Mach3

I have tried changing Kernel speeds. Maybe not enough video Ram in the PC ??

Anyone ?

Offline Tweakie.CNC

*
  • *
  •  8,706 8,706
  • Super Kitty
    • View Profile
    • Tweakie.CNC
Re: Mach3 help please / Steps jerking
« Reply #2 on: January 28, 2015, 02:52:03 AM »
Not much help really but...
It sounds like your video card ram is insufficient - try disabling the toolpath display (diagnostics screen) if everything then runs fine then that should be the proof you need.

Tweakie.
KEEP SAFE !