Hello Guest it is January 18, 2025, 07:14:23 PM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: Macro for setting coordinate rotation  (Read 9114 times)

0 Members and 1 Guest are viewing this topic.

vmax549

*
Macro for setting coordinate rotation
« on: March 02, 2006, 02:04:58 AM »
Brian you would not happen to have a macro that uses  the g31
function to set coordinate rotation, laying around would you ( actually need two, one for x and one for y rotation) ??? Just looking for a macro,  not a wizard..
(:-)= Terry
Logged

Offline Brian Barker

*
  • *
  • 3,860 3,860
Re: Macro for setting coordinate rotation
« Reply #1 on: March 02, 2006, 09:54:52 AM »
I  don't have it as a macro...
Logged
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com

vmax549

*
Re: Macro for setting coordinate rotation
« Reply #2 on: March 02, 2006, 08:01:48 PM »
Hi brian, do you have it as a wizard? Does it use the probe function?  Thanks Terry
Logged

Offline Brian Barker

*
  • *
  • 3,860 3,860
Re: Macro for setting coordinate rotation
« Reply #3 on: March 02, 2006, 08:11:48 PM »
I do :) 

I have not run this in a VERY long time... I did it one day when I had nothing to do... I think that is over now :(

Hope it helps
Brian
Logged
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com

vmax549

*
Re: Macro for setting coordinate rotation
« Reply #4 on: March 02, 2006, 09:24:39 PM »
Brian would you happen to have a set of instructions for the wizard? A simple how to do would be great .  Thanks Terry
Logged
Pages: 1   Go Up
« previous next »