Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: vmax549 on March 02, 2006, 02:04:58 AM
-
Brian you would not happen to have a macro that uses the g31
function to set coordinate rotation, laying around would you ( actually need two, one for x and one for y rotation) ??? Just looking for a macro, not a wizard..
(:-)= Terry
-
I don't have it as a macro...
-
Hi brian, do you have it as a wizard? Does it use the probe function? Thanks Terry
-
I do :)
I have not run this in a VERY long time... I did it one day when I had nothing to do... I think that is over now :(
Hope it helps
Brian
-
Brian would you happen to have a set of instructions for the wizard? A simple how to do would be great . Thanks Terry