Hello Guest it is April 23, 2019, 06:50:50 AM

Poll

I have a sherline 2000 mill with an 18 inch table. running on inch units. How do I home it to begin in the same position each time. like a point of origin.???  

sherline mach3
0 (0%)
mach3
1 (100%)

Total Members Voted: 1

Voting closed: January 06, 2015, 10:28:36 AM

Author Topic: homing  (Read 1038 times)

0 Members and 1 Guest are viewing this topic.

homing
« on: December 30, 2014, 10:28:36 AM »
I have a sherline 2000 mill with an 18 inch table. running on inch units. How do I home it to begin in the same position each time. like a point of origin.??? 
Re: homing
« Reply #1 on: December 30, 2014, 09:40:21 PM »
I would suggest that you take a little time and do some reading over at the cnczone.com forum.  This has been discussed and explained in great detail.