Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: ramhobbies on December 30, 2014, 10:28:36 AM

Title: homing
Post by: ramhobbies on December 30, 2014, 10:28:36 AM

I have a sherline 2000 mill with an 18 inch table. running on inch units. How do I home it to begin in the same position each time. like a point of origin.??? 

Title: Re: homing
Post by: rickinbeachcrest on December 30, 2014, 09:40:21 PM

I would suggest that you take a little time and do some reading over at the cnczone.com forum.  This has been discussed and explained in great detail.