Hello Guest it is July 18, 2019, 07:49:56 AM

Author Topic: Sharing Mach 3 config  (Read 1455 times)

0 Members and 1 Guest are viewing this topic.

Sharing Mach 3 config
« on: December 12, 2014, 11:11:38 AM »
Hi Guys
I've built a 4 axis Hot wire CNC  which can be seen at http://www.rckeith.co.uk I get quite a lot of questions from guys doing the same build and I always give them my full support.  I have a licensed version of Mach3 and it would be a great help to these guys if I could send them my Mach 3 config file.  My only concern is that would I be exposing my license and unwittingly be a software pirate.

Thanks
Keith
Thanks
Keith

Offline Hood

*
  •  25,849 25,849
  • Carnoustie, Scotland
    • View Profile
Re: Sharing Mach 3 config
« Reply #1 on: December 12, 2014, 01:26:53 PM »
No, your licence is not contained within the xml.
Hood
Re: Sharing Mach 3 config
« Reply #2 on: December 15, 2014, 03:14:21 AM »
Thanks Hood, helped me again.  Sorted a debounce issues I had a while back and its worked perfectly ever since.

Keith
Thanks
Keith