Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: rckeith on December 12, 2014, 11:11:38 AM
-
Hi Guys
I've built a 4 axis Hot wire CNC which can be seen at http://www.rckeith.co.uk I get quite a lot of questions from guys doing the same build and I always give them my full support. I have a licensed version of Mach3 and it would be a great help to these guys if I could send them my Mach 3 config file. My only concern is that would I be exposing my license and unwittingly be a software pirate.
Thanks
Keith
-
No, your licence is not contained within the xml.
Hood
-
Thanks Hood, helped me again. Sorted a debounce issues I had a while back and its worked perfectly ever since.
Keith