Hello Guest it is May 25, 2019, 12:31:30 AM

Author Topic: Getting Mach3 to start/stop on system clock  (Read 1200 times)

0 Members and 1 Guest are viewing this topic.

Getting Mach3 to start/stop on system clock
« on: November 26, 2014, 02:53:41 AM »
I have a series of mechanical tests that need to be run inside a test chamber after every cycle. I would like to do this automatically but I will like it to start/stop based on the computer clock rather than a delay set by G-code, is this possible?

Many thanks

Offline BR549

*
  •  6,865 6,865
    • View Profile
Re: Getting Mach3 to start/stop on system clock
« Reply #1 on: November 26, 2014, 09:48:06 AM »
Well you DO have access to the PC clock though scripting with CB.

(;-) TP