Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: mattco3 on November 26, 2014, 02:53:41 AM

Title: Getting Mach3 to start/stop on system clock
Post by: mattco3 on November 26, 2014, 02:53:41 AM

I have a series of mechanical tests that need to be run inside a test chamber after every cycle. I would like to do this automatically but I will like it to start/stop based on the computer clock rather than a delay set by G-code, is this possible?

Many thanks

Title: Re: Getting Mach3 to start/stop on system clock
Post by: BR549 on November 26, 2014, 09:48:06 AM

Well you DO have access to the PC clock though scripting with CB.

(;-) TP