Hello Guest it is May 24, 2019, 06:03:25 PM

Author Topic: pulse width  (Read 1857 times)

0 Members and 1 Guest are viewing this topic.

docltf

*
pulse width
« on: April 02, 2007, 12:57:26 AM »
i have been running my setup in sherline mode.if i where to take it out of sherline mode and start playing with the step and dir pulse width.what would be the largest number mach3 will recognize.

thanks bill 
Re: pulse width
« Reply #1 on: April 02, 2007, 07:58:30 AM »
You can take it up to 15 but after that you may lock up your system :(
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com