Hello Guest it is May 17, 2025, 05:41:59 AM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: Mach3 Controller Card Breakout Interface Board  (Read 4078 times)

0 Members and 1 Guest are viewing this topic.

Offline amnon

*
  • 40 40
Mach3 Controller Card Breakout Interface Board
« on: October 30, 2014, 12:17:03 PM »
Hej,

I bought USB Controller Card

http://www.ebay.co.uk/itm/3-Axis-USB-Controller-Card-400KHz-CNC-MACH3-Breakout-Interface-Board-Win7-8-XP-/261395836685?pt=UK_BOI_Industrial_Automation_Control_ET&hash=item3cdc67ef0d

I have problem with wireing this up. There is no Enable joints (just DIR and STEP)unlike my stepper motor driver. I read manual but I didn't find explanation why is that. Could soneone tell me how to make it work.

Respect
amnon
Logged

Offline TPS

*
  • 2,578 2,578
Re: Mach3 Controller Card Breakout Interface Board
« Reply #1 on: October 30, 2014, 03:00:47 PM »
Hi,
Quote from: amnon on October 30, 2014, 12:17:03 PM
I have problem with wireing this up. There is no Enable joints (just DIR and STEP)unlike my stepper motor driver. I read manual but I didn't find explanation why is that. Could soneone tell me how to make it work.
yes, yust figure it out.
Logged
anything is possible, just try to do it.
if you find some mistakes, in my bad bavarian english,they are yours.

Offline amnon

*
  • 40 40
Re: Mach3 Controller Card Breakout Interface Board
« Reply #2 on: October 31, 2014, 11:00:16 AM »
Quote
yes, yust figure it out.

but It doesn't work
Logged
Pages: 1   Go Up
« previous next »