Hello Guest it is March 28, 2024, 08:39:32 AM

Author Topic: turning feed hold problem  (Read 2241 times)

0 Members and 1 Guest are viewing this topic.

turning feed hold problem
« on: August 29, 2014, 07:05:36 PM »
mach3 turning.
I have the following program:
%
G21 G94
T0101 M06
X35 G00 Z5
X-4.8
Z2.
G2-.8 X Z0. I2. F150. "pressed Feed Hold"
G3 X18. Z-9.4 K-9.4 "I press Cycle Start"
"From that moment the cutting tool follows another taryectoria"
X15.643 13,957 Z-I-9.4
Z-20 819 G1 X8.036
X8 G2. Z-21.329-.511 K I7.314
G1 Z-25.447
X13.865
Z-G3 X14.634 25,738 K-4
X25.204 G1 Z-44.276
X26
G0 X35 Z5
M30
%
it may be happening.
Thank you for your attention.

Offline Hood

*
  •  25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: turning feed hold problem
« Reply #1 on: August 31, 2014, 04:22:30 AM »
Attach your xml please and I will take a look.
Hood
Re: turning feed hold problem
« Reply #2 on: September 11, 2014, 10:10:11 AM »
Sorry for the delay.