Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: jdmaya on August 29, 2014, 07:05:36 PM

Title: turning feed hold problem
Post by: jdmaya on August 29, 2014, 07:05:36 PM

mach3 turning.
I have the following program:
%
G21 G94
T0101 M06
X35 G00 Z5
X-4.8
Z2.
G2-.8 X Z0. I2. F150. "pressed Feed Hold"
G3 X18. Z-9.4 K-9.4 "I press Cycle Start"
"From that moment the cutting tool follows another taryectoria"
X15.643 13,957 Z-I-9.4
Z-20 819 G1 X8.036
X8 G2. Z-21.329-.511 K I7.314
G1 Z-25.447
X13.865
Z-G3 X14.634 25,738 K-4
X25.204 G1 Z-44.276
X26
G0 X35 Z5
M30
%
it may be happening.
Thank you for your attention.

Title: Re: turning feed hold problem
Post by: Hood on August 31, 2014, 04:22:30 AM

Attach your xml please and I will take a look.
Hood

Title: Re: turning feed hold problem
Post by: jdmaya on September 11, 2014, 10:10:11 AM

Sorry for the delay.