Hello Guest it is November 13, 2019, 01:41:29 AM

Author Topic: A Question.  (Read 1794 times)

0 Members and 1 Guest are viewing this topic.

Offline Tweakie.CNC

*
  • *
  •  7,985 7,985
  • Super Kitty
    • View Profile
    • Tweakie.CNC
A Question.
« on: June 27, 2014, 11:41:09 AM »
Will Mach4 provide a square wave PWM output signal (similar to Mach3) or will that be up to the external motion controller to produce. ?

Thanks.

Tweakie.
Success consists of going from failure to failure without loss of enthusiasm.  Winston Churchill.
Re: A Question.
« Reply #1 on: June 27, 2014, 12:49:58 PM »
Each plug-in or device must supply its own outputs including PWM and charge pump outputs.

For a parallel port, it is the Darwin driver that will generate the signals.
Steve Stallings
www.PMDX.com
For PMDX product support, please use PMDX forum or direct email for quickest response. We do not use this forum as our primary product support site.

Offline Tweakie.CNC

*
  • *
  •  7,985 7,985
  • Super Kitty
    • View Profile
    • Tweakie.CNC
Re: A Question.
« Reply #2 on: June 27, 2014, 02:42:49 PM »
Thanks.  ;)

Tweakie.
Success consists of going from failure to failure without loss of enthusiasm.  Winston Churchill.

Offline ART

*
  • *
  •  1,698 1,698
  • Tough as soggy paper.
    • View Profile
Re: A Question.
« Reply #3 on: June 28, 2014, 03:25:54 PM »
Tweak:

  I havent yet added that to Darwin, it can do a frequency, but I dont think I made it PWM as yet.. Ill have to look into that..

Art

Offline Tweakie.CNC

*
  • *
  •  7,985 7,985
  • Super Kitty
    • View Profile
    • Tweakie.CNC
Re: A Question.
« Reply #4 on: June 29, 2014, 01:49:49 AM »
Thanks Art.

Tweakie.
Success consists of going from failure to failure without loss of enthusiasm.  Winston Churchill.