Here is a sample of a Mach4 Manuals page where you can read the manuals AND a page were you can access THE NFS Mill Wizard and be running mach4 cutting a part and creating the next part at the same time.
It is a little shaky on running the Wizard, IF you MOVE the window Mach4 will stop untill you release the window grab.
But it DOES seem to work.
I created a Wizard part then load into Mach4 and ran while I created another part and saved ready to run. AND did a third part.
Interesting, AND I am sure there is a better way to do this BUT it worked.
(;-) TP