Ok after talking to the original owner we realized that it may just be a port issue . I went into the config /port pin section and it appears to be correct . . The machine will not jog around still. I'm going to run a new wire from the vdf to the cnc controller as I see that is causing the error on the vdf. That might be the culprit. Original owner rescheduled to see it Wednesday.

The wire is for the logics that will be replaced

well the owner had an unexpected thing pop up and said he may be able to come by today.

I am thinking I need to replace the logics wire that runs from the control to the phase converter. does anyone know what wire I should be using ?

Problem solved!! The original owner came by last night and we tested things for a couple hours  and had to install the software . And run a couple of new wires .!!!!!  now time to wrap things up so I can start cutting .  Thanks for all the replies

Great to hear the machine is up and running.

we have it up and running now !!! I put all file in my c drive but never installed the drivers   what was I thinking LOL