I have the ip address set to 192.168.1.100. If I ping 192.161.1.10, I get happy results. 0% data loss.
This leads me to believe that I have stable comm between the pc and the g100.
One possibility is that I have loaded the wrong firmware into the g100.
The instructions were a little vague on that point.
I'd like to try to re-load, but I can't seem to find a procedure for this.
Now, If I use the g-rex loader, I can't get to the html screen, I only get a blank browser.
I'd like to back up and start again, if I can figure out how.