Hello Guest it is September 25, 2023, 09:05:10 AM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: Cam Bam Post Processor to Mach3  (Read 2033 times)

0 Members and 1 Guest are viewing this topic.

Offline Evanrigs

*
  • 9 9
    • View Profile
Cam Bam Post Processor to Mach3
« on: March 07, 2014, 02:19:50 PM »
When using cambam to mach 3, how important is it to set the post processor in the machining file?
Logged

Offline RICH

*
  • *
  • 7,427 7,427
    • View Profile
Re: Cam Bam Post Processor to Mach3
« Reply #1 on: March 07, 2014, 06:03:41 PM »
The post processor is used by Cambam to adjust the generated code so it is appropriate for Mach use and not some other controller.

RICH

Logged
Pages: 1   Go Up
« previous next »