When I run Grex-Loader I find the G100, but when I hit Launch Firmware Loader, it doesn't connect. I was able to the first time - when I updated the firmware, but after the firmware was submitted, it has never been able to go beyond the Find Gecko stage.
Here's what I did: Uunpacked my new G100, hooked up a crossover Enet cable, USB cable, installed USB drivers per the Dummies document, ran Grex-Loader, clicked Find Gecko, G100 found, changed IP & subnet, found again, followed dummies doc to the point where it asked to load second firmware. Blam... never could get to the Launch Firmware Loader again. PS - tried both crossover and going through a linksys router using regular Cat5e. Even tried a different computer. No change. Powered on/off, red light goes on for about 10 secs (I changed it when I could get into the G100). Then it goes out, no LEDs lit.
Any ideas?