Hello Guest it is May 25, 2019, 05:53:41 AM

Author Topic: have Version R3.043.066 ... and am new . with questions  (Read 1361 times)

0 Members and 1 Guest are viewing this topic.

have Version R3.043.066 ... and am new . with questions
« on: January 21, 2014, 03:22:56 PM »
I have it basically running with my home built CNC but I'm looking for the settings for Safe Z (according to the doc's version 1.84 (I think that was the version I saw)  the screens look nothing like what I have. in the do'c it loooks easy just click a setting and adjust ads needed to make it you height. on my screens it isn't there? anyone know where it is in Version R3.043.066 so I can get it working.
thanks
Re: have Version R3.043.066 ... and am new . with questions
« Reply #1 on: January 21, 2014, 03:29:26 PM »
Under Config.
John Champlain
Re: have Version R3.043.066 ... and am new . with questions
« Reply #2 on: January 21, 2014, 04:31:01 PM »
Under Config.
John Champlain

OK!  thanks very MUCH!
 I was looking in the logic section and never let my eyes wander down any further. (DUH moment) now it won't trash my piece when  I forget to raise it after an oops!