Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: keastab on January 21, 2014, 03:22:56 PM

Title: have Version R3.043.066 ... and am new . with questions
Post by: keastab on January 21, 2014, 03:22:56 PM
I have it basically running with my home built CNC but I'm looking for the settings for Safe Z (according to the doc's version 1.84 (I think that was the version I saw)  the screens look nothing like what I have. in the do'c it loooks easy just click a setting and adjust ads needed to make it you height. on my screens it isn't there? anyone know where it is in Version R3.043.066 so I can get it working.
thanks
Title: Re: have Version R3.043.066 ... and am new . with questions
Post by: Picengraver on January 21, 2014, 03:29:26 PM
Under Config.
John Champlain
Title: Re: have Version R3.043.066 ... and am new . with questions
Post by: keastab on January 21, 2014, 04:31:01 PM
Under Config.
John Champlain

OK!  thanks very MUCH!
 I was looking in the logic section and never let my eyes wander down any further. (DUH moment) now it won't trash my piece when  I forget to raise it after an oops!