Hi Ger21
I just cloned an xml, changed the native units from inch to mm, and the DRO didn't change.
So just to be sure, I went to the MDI and entered g21. Nothing changes
I move the z axis 1.00 unit, and it moves 1.00"
Enter g20 in the MDI and the DRO changes numbers.
Now if I want to move 1.00" the DRO reads .0394
So, it's like g21 and g20 are reversed... (?)
I've tried with "Lock DRO to setup units" ticked and without.
I have a load of in/outs, macros, Ethernet SmoothStepper, etc. that make the thought of a fully-virgin setup really unappealing. Is there any way to work through this one issue?
TIA