Hello everyone!
Its been awhile since I've cruzed the forums here, but its great to see Mach3 still holding strong, and Mach4 coming soon!
I've been overhauling and upgrading my machine, and have now come into a problem.
I've rewired the machine with shielded cable, and pretty much completely eliminated all noise!
I used to run my debounce at 2000, but now I can reliably run the machine with it at 50!
*EXCEPT*
For when I home my axis in the Y direction!
Both Z and X axis will home correctly with a debounce setting of 50,
but the Y axis requires a minimum debounce of 1250, before it causes the limit switch to trip the machine.
I've been scratching my head or a few hours with this one, but can't nail it down.
any thoughts on why just the Y axis would require the higher debounce setting?
Thanks!
Chris
P.S. I'm not sure if this is a carry over from before the upgrades or not, as the debounce was set at 2000 before.
I'm pretty sure the machine is wired exactly as before, just with new wires.