Hello Guest it is April 19, 2024, 06:11:59 AM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: Mirror milling  (Read 3370 times)

0 Members and 1 Guest are viewing this topic.

Offline Goldy999

*
  • 7 7
    • View Profile
Mirror milling
« on: December 23, 2013, 10:15:33 AM »
I have mange to start cnc from China. But it mills teks wrong way. I am not DaVinci, so I would like to repair this. Does somebody knows whath to do.


Please help
Logged

Offline Tweakie.CNC

*
  • *
  • 9,198 9,198
  • Super Kitty
    • View Profile
Re: Mirror milling
« Reply #1 on: December 23, 2013, 11:05:12 AM »
In Config / Ports & Pins / Motor Outputs change the 'Dir Low Active' state for the axis that is machining backwards

Tweakie.
Logged
PEACE

Offline Goldy999

*
  • 7 7
    • View Profile
Re: Mirror milling
« Reply #2 on: December 23, 2013, 12:57:28 PM »
Thank you. the first letter word the mill make ok other again in mirror state.
Logged

Offline Goldy999

*
  • 7 7
    • View Profile
Re: Mirror milling
« Reply #3 on: December 23, 2013, 01:35:20 PM »
It works Eureka. Thank you veary much once again.

Do you mybee know how to kontrol spindle in PWM mode. if I have on PWM mode it runs on full speed. komand M5 doesentz help.

You aree the men!!!!
Thanks once again on help.

Best regards,

Gregor
Logged

Offline Tweakie.CNC

*
  • *
  • 9,198 9,198
  • Super Kitty
    • View Profile
Re: Mirror milling
« Reply #4 on: December 24, 2013, 02:11:18 AM »
Quote
Do you mybee know how to kontrol spindle in PWM mode. if I have on PWM mode it runs on full speed. komand M5 doesentz help.

Hi Gregor,

If you return to the main page and enter    pwm spindle control    in the search box it will throw up lots of information on how it has been done.

Tweakie.
Logged
PEACE
Pages: 1   Go Up
« previous next »