I have got to the stage where I am doing test runs on my almost completed router.
I have set velocity and acceleration to a conservative level on the Z axis.
When jogging at 100% or doing G0 moves on the MDI screen the Z moves very smoothly.
Then when air cutting the Roadrunner, I can hear that the Z is jumping steps as it ends a move.
It is like it moves too quickly and stops too suddenly. Either up move or down.
Should not the velocity and acceleration as set in Motor Tuning be the overriding limit?
I just had a thought
Setting the scale up to 10 may have affected this ....... would it
If that is so then changing the scale at the DRO discards the motor tuning. Could this be so