Hello All,
I am having a homing issue and looking for a little advice. I am using Mach3 to run my homemade CNC router. This machine has four motors, one for X one for Z and two for the Y direction...Y and A. I have slaved the A motor with the Y and it works just fine while running BUT when i home the Y,  that is the only motor that homes, A does not move and as you may see it causes my machine to become out of square.

any help would be appreciated

thank you
john

On General Config page there is an option for homing slave with Master.
Hood

thank you Hood......Its working now.
John