Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: rhys on August 15, 2013, 07:38:52 AM

Title: Homming issue
Post by: rhys on August 15, 2013, 07:38:52 AM

Hello All,
I am having a homing issue and looking for a little advice. I am using Mach3 to run my homemade CNC router. This machine has four motors, one for X one for Z and two for the Y direction...Y and A. I have slaved the A motor with the Y and it works just fine while running BUT when i home the Y,  that is the only motor that homes, A does not move and as you may see it causes my machine to become out of square.

any help would be appreciated

thank you
john

Title: Re: Homming issue
Post by: Hood on August 18, 2013, 04:38:30 AM

On General Config page there is an option for homing slave with Master.
Hood

Title: Re: Homming issue
Post by: rhys on August 18, 2013, 07:51:38 AM

thank you Hood......Its working now.
John