Author Topic: Macro for finding egde alignment  (Read 998 times)

0 Members and 1 Guest are viewing this topic.

Offline hacker77

  • Active Member
  • Posts: 32
    • View Profile
Macro for finding egde alignment
« on: July 21, 2013, 11:06:17 AM »
Hey guy's looking for a macro to  align material in the Y direction and the X direction.
Like doing a probe on the -Y then retract and go to the +Y direction and give a distance
 the part is out of alignment. Hope this makes sense. I found this picture but can't seem to get
a hold of the owner of it. Crap after looking at it again I need alot of macros.
Or a similar screen that can be added to Mach 3.  Thanks Richard
« Last Edit: July 21, 2013, 11:10:03 AM by hacker77 »