Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: hacker77 on July 21, 2013, 11:06:17 AM
-
Hey guy's looking for a macro to align material in the Y direction and the X direction.
Like doing a probe on the -Y then retract and go to the +Y direction and give a distance
the part is out of alignment. Hope this makes sense. I found this picture but can't seem to get
a hold of the owner of it. Crap after looking at it again I need alot of macros.
Or a similar screen that can be added to Mach 3. Thanks Richard