I have two wabeco machines :
6000 series lathe with 8 position toolchanger.
Mill with rotary table.
Both spec with ball screws, and the mill with linear guides etc.
They both currently use the Kosy NCCAD 7 system which leaves a lot to be desired, although I have made good progress thus far. However today I had a task that required :
34mm dia, Left hand internal thread. 4.75mm pitch. Wabeco have advised that the controller cannot do that ! So I have a couple of queries,
1 - Is the mach 3 system capable to cutting such a thread ?
2 - I currently do the design and technology in the CAD stage of NCCAD, how does that process equate to Mach 3 ?
I have a vendor that can supply new controllers, I just wish to clarify the processes of using the system and what it is capable of.
TIA for any feedback.