Jaime - this is why I asked you to check the profile name bottom right and post your xml - it's the easiest way for us to check your setup without continually guessing.

Ian

Sorry I do that tonight. and I try again.  I let you know

Hi Ian and Dave I check my system again and  everuthing look ok but stillmy mototr no move.
My profile name its  MILL_JAC.
I also check my comupter port for signal and this its what I found out.
port #2 .16v pressing the - or +
port#3  3.23v when I press the  - and stay like that till i press the + then it goes to 0v  and same thing happen to the other Y,Z.
Also I check the drivers and when its done it said Mach1 test complite  OK

Im trying to atach some pics so you can check my stting but  for some reason I cant , its getting late now I try again tomoorow.

Thank you

Jaime - I didn't ask for the NAME of your profile and I didn't ask you to post pictures. Please re-read my first reply and post your xml FILE.

Ian

OK. you talking about the one on mach3 folder under mach3mill.xml . I attache it tonight. sorry for all this confusion. Think Im trying to do  things too fast.

Thank you Ian

Jaime

if your profile name is MILL_JAC, your xml file will be named MILL_JAC.xml .

John

Hi John, thank you. Think I got it now.

Hi Ian, think this is what you been asking for since the begining. If not let me know and I look for it again,  sorry for all this trouble and thank you for all your time and help.

XML looks fine so...

port #2 .16v pressing the - or +
port#3  3.23v when I press the  - and stay like that till i press the + then it goes to 0v  and same thing happen to the other Y,Z.

Looks like you have a 3.5V parallel port. If this is the case you'll need to either add a new 5V parallel port card or a BOB that will accept 3.5V in and provide 5V out.

Ian