Hello Guest it is March 29, 2024, 11:05:42 AM

Author Topic: 3040Z issues again.....  (Read 11427 times)

0 Members and 1 Guest are viewing this topic.

Re: 3040Z issues again.....
« Reply #30 on: May 17, 2013, 03:17:51 PM »
Great the BOB and stepper driver boards came in from China today.  Installed the hardware, started Mach3 and damned if I still don't have the same problem with the Z axises.  I jogged the y all the way to the end of the table, tried the Z and it worked fine.  Move to the middle of the table, did not work.  Move back to the end, works.  Besides having to replace the one driver board, this really sounds like a wiring issue.  My continuity tester is at a job right now...

Any advise?  Replace the one faulty wire or should I replace all of them?