So, I opened up Mach3Screen, double clicked Rev All-Home and added Code("x0y0z0") to the end of the normal sequence of:
DoButton( 24 )
DoButton( 23 )
DoButton( 22 ).
The hope was to get the machine to move to 0,0,0 from the Home Offsets.
It does the DoButton sequence then stops. If I Ref All-Home again,THEN it does the x0y0z0. THEN, it proceeds to do the DoButton sequence again.
So, I changed it to:
DoButton( 24 )
Code("z0")
DoButton( 23 )
Code("y0")
DoButton( 22 )
Code("x0")
Again, it does something very similar. It completes the Dobutton's the first time its selected putting in the offset values. Then it zero's x, y, z the second time it's selected, then goes through the DoButton sequence again.
The net result being, that I'm always left at the Home Offsets and never at 0,0,0.
How can I get it to move to 0,0,0 after doing a Ref All-Home?