Hello Guest it is June 18, 2019, 11:44:00 AM

Author Topic: Have someone a solution for this issue?  (Read 1727 times)

0 Members and 1 Guest are viewing this topic.

Have someone a solution for this issue?
« on: March 23, 2013, 02:23:25 PM »
Hello Together

I use a mill and a lathe. Both with Mach3 . Now I work offten with more tools and sometimes If I correct a measure , I want to get in the program on the tool I have done a correction.

I choose the line I want to get in ...push the green N ( or start from here ) but it didn´t work.  Have someone the same problem with this.

I got this issue on both machines.

Thank You

Offline Hood

*
  •  25,844 25,844
  • Carnoustie, Scotland
    • View Profile
Re: Have someone a solution for this issue?
« Reply #1 on: March 23, 2013, 02:39:50 PM »
I presume you are meaning Run From Here?
If so then it does not work with demo version of Mach.
Hood
Re: Have someone a solution for this issue?
« Reply #2 on: March 23, 2013, 03:56:39 PM »
Hello Hood

Its already licensed now. But anyway it didn´t work.

Specialy now on the lathe where after the threading issue I put in the license once more... But threading now is fine  ;D



Offline Hood

*
  •  25,844 25,844
  • Carnoustie, Scotland
    • View Profile
Re: Have someone a solution for this issue?
« Reply #3 on: March 23, 2013, 05:30:25 PM »
If you attach the code and your xml and tell me which line you are trying to do the Run From Here from I will see if I can find the issue.
Hood