I'm bringing up a Mach3 driven lathe using the 057 version. Thanks to some help from the nice guy at PMDX (real nice breakout boards) I've got it 98% working, axis drives are working well, MPG is working on X and Z, spindle speed/direction control is working, E stop and charge pump are working.
I'm using a joy stick connected to an IPAC with keygrabber to generate key codes to do the jogging.
This was actually the first thing I set up and it was working fine at first.
But something I've done in the following setup caused the jogging to stop working. I've double (and triple) checked that keygrabber is seeing the joy stick switch closes and is sending out the correct key codes and they are the ones set in the Mach hotkey config menu.
Also its set to Continous jog and the jog rate has a non-zero number. But no jogging occurs (no change in the axis DRO's either).
Is there some other Mach setting I could have accidentally changed when setting up the other stuff that could have disabled the jogging?
Thanks,
Paul T.