Hello Forum,
I have been running an 1.7 ghz XP based system for years with version 1.83 of Mach3. I have had no trouble until this past weekend. I have a two sided part I was routing. I turned the part over, reset home and loaded the gcode. I didnt pay too much attention to the toolpath display. The router stopped mid-stream and when I checked the toolpath display, I noticed it stopped on line 500. Why was it in demo mode. The license info was at the top of the screen. I rebooted, and this time it loaded the entire gcode in the display, however, when I scrolled through the code, it stopped at line 500. I tried several different codes with the same result. Once in a while it will load the entire code. I am stumped. This is a standalone machine with no internet connection and nothing has been changed. I do only have 256mb of ram, which is the only thing that might be marginal, but it has run for years. Any ideas?
Thank you,
Wayja