Hmmm, you may be correct, I could not recall if this is set in my CAM program that generates the G code (I have looked in both Mach and CAM setups) but cannot seem to locate it in either place
I know it was a constant I set at some point in time.....but I have slept since then and forgot
This is the line at the beginning of the code that sets it to 0.8"
N140G00G43Z0.8000H1
And then again at the end before it returns to the home position.
N56850G00Z0.8000
N56860G00X0.0000Y0.0000