Hello,
After venturing down a blind path with modbus/arduino and an Optimum branded chinese encoder I'm at a stand still.
Well untill I figured out to take the signal from the display on the lathe and feeding that into an input pin on my breakout board.
Problem now is that the STrue value is 4 times the actual rpm, which is because of the sensor receiving 4 signals per rotation.
I thought I could make a brain that just divided the value, but that doesn't seem to be the case.
[Spindle Index]---->[/4]---->[Spindle Index]
I'm fairly new at this, so I might go the wrong way about it
--
Kind regards,
Jens