Hello Guest it is March 28, 2024, 05:22:41 PM

Author Topic: waiting/calculation time inbetween passes  (Read 4103 times)

0 Members and 1 Guest are viewing this topic.

waiting/calculation time inbetween passes
« on: March 05, 2013, 07:01:32 AM »
Hi Guys,

I am looking for a solution for my problem:

At the end of each pass  my tool is not moving for lets say half a second : this causes extra wear of my tools. (using g01 codes)

(Mach3 seems to need some execution/calculation time before starting the next pass)

Do i need a faster computer or can i use a command/change settings  that speeds things up?

thanks
Mark

Offline Chaoticone

*
  • *
  •  5,624 5,624
  • Precision Chaos
    • View Profile
Re: waiting/calculation time inbetween passes
« Reply #1 on: March 05, 2013, 08:50:08 AM »
Post your code and xml file and I'll take a look.  Sounds like you have some weirdness going on.

Brett
;D If you could see the things I have in my head, you would be laughing too. ;D

My guard dog is not what you need to worry about!
Re: waiting/calculation time inbetween passes
« Reply #2 on: March 08, 2013, 05:14:24 AM »
Hello Brett, thanks for your kind reply.
Re: waiting/calculation time inbetween passes
« Reply #3 on: March 08, 2013, 05:18:09 AM »
Brett, could it be an    exact stop mode   issue ?

Offline Chaoticone

*
  • *
  •  5,624 5,624
  • Precision Chaos
    • View Profile
Re: waiting/calculation time inbetween passes
« Reply #4 on: March 08, 2013, 10:25:05 AM »
Simulating your code here in your profile, I see no delay.  Have you checked your backlash?

Brett 
;D If you could see the things I have in my head, you would be laughing too. ;D

My guard dog is not what you need to worry about!
Re: waiting/calculation time inbetween passes
« Reply #5 on: March 08, 2013, 10:29:13 AM »
Hi Mark and Brett
it's not CV causing this.
In General Config you checked " Z is 2,5 D on Output #6 "
UNCHECK this

Alex
Re: waiting/calculation time inbetween passes
« Reply #6 on: March 08, 2013, 10:42:51 AM »
Hi Alex /Brett : Thanks for both your replies .


Alex :  You were right Unchecking did the trick !!


thanks again

Mark


Offline Chaoticone

*
  • *
  •  5,624 5,624
  • Precision Chaos
    • View Profile
Re: waiting/calculation time inbetween passes
« Reply #7 on: March 08, 2013, 11:05:57 AM »
 :)

Good job Alex, Thanks,
Brett
;D If you could see the things I have in my head, you would be laughing too. ;D

My guard dog is not what you need to worry about!
Re: waiting/calculation time inbetween passes
« Reply #8 on: March 08, 2013, 11:48:06 AM »
Thanks Brett. ;D
Alex