Hello Guest it is March 28, 2024, 10:49:11 AM

Author Topic: Touch plate info wanted  (Read 2702 times)

0 Members and 1 Guest are viewing this topic.

Touch plate info wanted
« on: February 08, 2013, 03:54:10 AM »
hi all,

just been reading up on touch plates.

could i get some info on whats needed to make one work.

what voltage does it need to be and what pins to i connect it to?

Offline RICH

*
  • *
  •  7,427 7,427
    • View Profile
Re: Touch plate info wanted
« Reply #1 on: February 08, 2013, 04:43:47 AM »
Re: Touch plate info wanted
« Reply #2 on: February 08, 2013, 05:16:56 AM »
thanks, he says

one end of the electrical connection is soldered to the PCB whilst the other end is connected to pin 15 of the LPT port

so am i simply connecting a wire from the touch plate to pin 15. it sounds to simple?

Offline budman68

*
  • *
  •  2,352 2,352
    • View Profile
Re: Touch plate info wanted
« Reply #3 on: February 08, 2013, 05:21:31 AM »
It really is that simple but you must be sure the spindle is not insulated or it won't pick up the contact from the cutter tip. If it is insulated, you can just ground a cable to an alligator clip and attach it to the cutter itself to create the circuit.

Also, don't forget to enable the probe in Ports and pins in Mach.

Dave
----------------------------------------------------------------------
Just because I'm a Global Moderator, don't assume that I know anything !

Dave->    ;)
Re: Touch plate info wanted
« Reply #4 on: February 08, 2013, 05:23:53 AM »
wow ok thanks, ill be setting this up today cheers.

i might post back if i get some issues setting mach up

thanks