I have a CNC router that I recently replaced the breakout board to a cnc4pc
C11G. I was setting up Mach3, and everything seems to work just fine except for
when I home the axes. The Y and Z home perfectly fine. They trigger the
proximity switches and back off, but the X axis triggers it's switch and doesn't
back off. It just stops at the switch and keeps it triggered.
Then I have to Reset, then toggle the active switches, move the X-axis, it
triggers the proximity switch again, reset, toggle active switches, and then I
can move the X-axis freely.
I also have all the axes set with Auto Zero enabled, and that doesn't seem to
work either.
Any ideas?
Thanks,
Matt