Hello,
ok i will use the older Version which works .

But i have still the Problem, my spindle does not run
If i use the german Version, i can turn on and of, with the original Version it does not start.
I have made the same Settings.
I only need a PWM on Pin 1 of LPT, then my drive starts, but PWM  seems not to be on pin 1.
Can youplease tell me which settings are neccesary

Thanks
Eberhard

attach the xml from the German setup and also the one from the current setup and I will look.
Hood

Hi, the problem with the spindle is solved. In the config of ESS PWM was not checked. I have klicked on it, but have forgotten to restart mach3
With the homing-problem, the older Versionof english mach 3 works...