Hi Guys,

recently been playing with the G41/42 codes to learn how to apply them to serially produced parts.

Was pulling my hair out for a while as the toolpath display was not showing the White trajectory lines on some of my CAM produced gcode.

I know that there are limitations in the G41/42 callout so I have researched ans stuck to them. What is funny though, once the code was corrected the white trajectory still failed to show and Mach was not giving an error.

If I simulate the trajectory though, the green trajectory tracer follows the line that should be white.

If I half the length of the program, the white trajectory appears.
So I am confident that all is good and that the only issue is the length of the program.

Anyone else seen this?