Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: komatias on January 01, 2013, 11:46:58 AM
-
Hi Guys,
recently been playing with the G41/42 codes to learn how to apply them to serially produced parts.
Was pulling my hair out for a while as the toolpath display was not showing the White trajectory lines on some of my CAM produced gcode.
I know that there are limitations in the G41/42 callout so I have researched ans stuck to them. What is funny though, once the code was corrected the white trajectory still failed to show and Mach was not giving an error.
If I simulate the trajectory though, the green trajectory tracer follows the line that should be white.
If I half the length of the program, the white trajectory appears.
So I am confident that all is good and that the only issue is the length of the program.
Anyone else seen this?