Hello Guest it is March 28, 2024, 05:33:51 AM

Author Topic: CHNC retrofit  (Read 9696 times)

0 Members and 1 Guest are viewing this topic.

Offline Hood

*
  •  25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: CHNC retrofit
« Reply #10 on: February 09, 2008, 05:01:17 PM »
What do you mean by " Where did the Artsoft Convention go"

Hood
Re: CHNC retrofit
« Reply #11 on: February 09, 2008, 08:49:34 PM »
I saw a notice of a convention for Mach in Knoxville, TN., and now I don't see anything about it. It was supposed to be February 23,24th, I think
Larry
Re: CHNC retrofit
« Reply #12 on: February 09, 2008, 09:30:07 PM »
The header for the convention and the header for the you tube videos are both gone. 

Offline Hood

*
  •  25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: CHNC retrofit
« Reply #13 on: February 10, 2008, 04:19:14 AM »
The third topic down is for the convention.
Hood
Re: CHNC retrofit
« Reply #14 on: July 09, 2011, 09:53:34 PM »
Hi every one 

i would also be interested in  what  parts  you used for  retrofitting of chnc1  like what brakout board .
what controllers and encoders and any other parts you can think of .

wiring diagrams for the new parts might be pushing it i know butt thought i would ask.

i will start by  what do you guys think of the smooth steper board C23 it has a two parallel port i gess 1 port for the computer and the other for tool changer

what are your thoughts

Offline jeep534

*
  •  123 123
  • From the hills of WV
    • View Profile
Re: CHNC retrofit
« Reply #15 on: July 20, 2011, 08:09:07 AM »
there are a couple of machines detailed it the show and tell section
archie =) =) =)
Facebook archies machine