Hello Guest it is April 24, 2024, 01:57:29 AM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: AMP's 10A8 and servo's 14203c790  (Read 2685 times)

0 Members and 1 Guest are viewing this topic.

Offline jal

*
  • 2 2
    • View Profile
AMP's 10A8 and servo's 14203c790
« on: November 13, 2012, 02:32:31 AM »
I have PWM SERVO AMPLIFIER 10A8 and servo motors with encoders 14203c790. Can I connect those to Mach3?

I got old SMD machine with those aps and servos. Max working area can be something like 50cmx50cm.
Logged

Offline Hood

*
  • 25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: AMP's 10A8 and servo's 14203c790
« Reply #1 on: November 13, 2012, 02:36:57 PM »
If these drives need an analogue (-10 to +10v) input then you would require one of the motion controllers that can take commands from Mach and output an analogue voltage.
There are a few
Galil
DSPMC
CSMIO-IP/A
Kflop with Kanalog

Hood
Logged

Offline jal

*
  • 2 2
    • View Profile
Re: AMP's 10A8 and servo's 14203c790
« Reply #2 on: November 14, 2012, 02:22:49 AM »
Maybe it's easier and cheaper to buy some Nema23 steppers from ebay?
Logged
Pages: 1   Go Up
« previous next »