Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: jal on November 13, 2012, 02:32:31 AM
-
I have PWM SERVO AMPLIFIER 10A8 and servo motors with encoders 14203c790. Can I connect those to Mach3?
I got old SMD machine with those aps and servos. Max working area can be something like 50cmx50cm.
-
If these drives need an analogue (-10 to +10v) input then you would require one of the motion controllers that can take commands from Mach and output an analogue voltage.
There are a few
Galil
DSPMC
CSMIO-IP/A
Kflop with Kanalog
Hood
-
Maybe it's easier and cheaper to buy some Nema23 steppers from ebay?